Most Dell computer systems are classified by the
Federal Communications Commission (FCC) as Class B digital devices. To determine
which classification applies to your computer system, examine all FCC
registration labels located on the bottom, side, or back panel of your computer,
on card-mounting brackets, and on the cards themselves. If any one of the labels
carries a Class A rating, your entire system is considered to be a Class A
digital device. If all labels carry an FCC Class B rating as
distinguished by either an FCC ID number or the FCC logo, (),
your system is considered to be a Class B digital device.
Once you have determined your systems FCC classification, read the
appropriate FCC notice. Note that FCC regulations provide that changes or
modifications not expressly approved by Dell could void your authority to
operate this equipment.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the following two conditions:
This device may not cause harmful interference.
This device must accept any interference received, including interference
that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a
Class A digital device pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the manufacturers instruction manual, may cause harmful
interference with radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference, in which case you will
be required to correct the interference at your own expense.
This equipment has been tested and found to comply with the limits for a
Class B digital device pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
manufacturers instruction manual, may cause interference with radio
communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the
equipment off and on, you are encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/television technician for help.
),
your system is considered to be a Class B digital device.